User's Manual

Draft
R00.e RT System 2 v2.0.0 Deployment Guide 17
© 2010-2012 Wireless Seismic, Inc. All rights reserved.
2. Layout
Laying Out the Equipment
2.4.2 Assembling the Ground Equipment
This section describes the process to assemble the ground equipment prior to
deployment.
To assemble the ground equipment:
1 Gather the equipment:
● WRU
● Antenna
● Geophone
● Batteries
2 Gather any special tools:
● Optional: Nylon grip pliers
● Optional: Loctite® 222
3 Attach one or more batteries to the WRU.
● Press the battery into the connector.
● Flip the bail over the molded area on the end of the battery.
● Press the lever until the catch snaps to lock it in place.
WARNING
In order to comply with FCC radio frequency (RF) exposure
requirements, the RT System 2 units must be installed so that a
minimum separation distance of 20 cm is maintained between the
antenna(s) and the body of all persons at all times during normal
operation.
WARNING
AVERTISSEM
ENT
Afin de se conformer aux normes de la FCC en matière d'exposition aux
radiofréquences (RF), les unités RT System 2 doivent être installées de
manière à garder en permanence une distance minimale de 20 cm entre
la ou les antennes et le corps de toute personne en mode de
fonctionnement normal.