User's Manual Part 2

Draft

120 RT System 2 v2.3.0 Deployment Guide R01.b

5. Point-to-Multipoint Backhaul

Final Communication Test

b Type ubnt in the User text box.

c Type

ubnt in the Password text box.

d Type

80 in the Remote WEB Port text box.

e The default test Direction is duplex; the test is performed for both transmit and

receive. If you want to run the test in only one direction, perform the following steps:

1) Select the Show Advanced Options check box.

2) Select transmit or receive.

f Click Run Test.

g If the following error is displayed, type 443 in the Remote WEB Port text box and

click Run Test.

Error: Invalid remote port or web server is not running.

h Good Test Results are as follows:

► RX (receive) only = 70+ Mbps

► TX (transmit) only = 70+ Mbps

► Total (duplex) = 90+ Mbps

– RX = 40+ Mbps

– TX = 40+ Mbps

7 Click another line segment radio IP address in the Select Destination IP list, click Run

Test, and then check results. Repeat for all line station radios.

8 If Speed Test results are low, perform the following steps for a Bullet radio. (Go to step

9 on page 122):

a Log in to the line station radio that displayed low Speed Test results.

b Click the Status tab and verify the following values:

► WSI-MAX (AirMax) Quality > 80%. If the value is < 80%, check the following:

Figure 5–20 Speed Test Window