User's Manual Part 2

Draft
R01.b RT System 2 v2.3.0 Deployment Guide 105
© 2010-2013 Wireless Seismic, Inc. All rights reserved.
5. Point-to-Multipoint Backhaul
Preparation
2 Configure the computer to be a private network with a static IP address of
192.168.1.100. See the Troubleshooting Guide, Additional Information chapter,
Setting a Static IP Address section if you need instructions on setting the IP address
(Control Panel
→ Network and Internet → Network and Sharing → Change
adapter settings
→ LAN → Properties → IPv4 → Properties).
3 Connect a single radio to the computer.
4 Open the Ubiquiti Discovery Tool by double-clicking the shortcut on the desktop.
LINE_RADIO_9.cfg LINE_RADIO_8.cfg LINE_RADIO_7_RECORDER_A.cfg
LINE_RADIO_10.cfg LINE_RADIO_9.cfg LINE_RADIO_8_RECORDER_B.cfg
LINE_RADIO_11.cfg LINE_RADIO_10.cfg LINE_RADIO_9_RECORDER_C.cfg
NOTE
When using a radio link (pendant) to the recording truck, the following
configuration files are also required:
• Recorder-AP.cfg
•Recorder-S.cfg
Figure 5–8 Ubiquiti Rocket/Bullet Private Network Connection
Table 5–2 Example File Names
Standard
Configuration
Redundant
Configuration
Custom Configuration