User's Manual Part 2
Draft
RT System 2 v2.3.0 143 Deployment Guide R01.b
© 2010-2013 Wireless Seismic, Inc. All rights reserved.
A
A. Legal Information
See “l'information juridique” on page 198 for the French translation of this chapter.
Voir “l'information juridique” sur la page 198 pour la traduction française de ce chapitre.
A.1 FCC Rules and Regulations Compliance
The Federal Communications Commission (FCC) regulates the use of antennas in the
“Code of Federal Regulations – Title 47, Part 15 – Radio Frequency Devices, Subpart C –
Intentional Radiators, Section 15.203 Antenna Requirement.”
When used as intended, the RT System 2 complies with FCC Section 15.203 and
Industry Canada RSS-Gen 7.1.2 requirements as follows:
The RT System 2 antennas shall be installed and handled by professionals
specifically designated for this purpose.
Changes or modifications not expressly approved by Wireless Seismic, Inc. can void
the users’s authority to operate the equipment.
The RT System 2 shall be used with only the supplied antennas (Table A–1) attached
to the WRU or LIU with an integrated type N male connector.
NOTE
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the
interference at his own expense.
Table A–1 Antenna Specifications
Model
Frequency
(MHz)
Gain
Vertical
Bandwidth
Weight
Dimension
(Length x
Diameter)
WSI 65-0204
(antenna-standard)
2400 5.5 dBi 25° 0.4 lbs
.2 kg
32 x 0.6 in
810.5 x 15 mm
WSI 65-0091
(extender-standard)
2400 0 dBi N/A 0.6 lbs
0.3 kg
30 x 0.7 in
762 x 18.5 mm
WARNING
WARNING
In order to comply with radio frequency (RF) exposure requirements, the RT
System 2 units must be installed so that a minimum separation distance of 20
cm is maintained between the antenna(s) and the body of all persons at all times
during normal operation.