User's Manual

R01.i RT System 2 v2.3 Deployment Guide 49

3. Backhaul

Backhaul Components

3.2.9 Mast and Base

The line and recorder backhauls use the same mast kit components.

3.2.9.1 Telescoping Mast

Telescoping backhaul masts are used to elevate the backhaul components above obstructions

and to enable radio communications to accommodate typical cross-line distances. The mast

is stabilized with guy ropes. The following figure shows the mast:

3.2.9.2 Base

The base (shown in the following figure) stabilizes the mast that is attached to the hinged

mast sleeve. The base is staked into the ground for added stability.

R* RED NC —

M* NC —

* Install a 1.5 inch long jumper wire between pins R and M

WHT = White, ORG = Orange, GRN = Green, BLU = Blue, BRN = Brown, BLK= Black, YEL = Yellow

Table 3–9 Cable Pinout, Backhaul Jumper (60-0033)

14-Pin Connector Wire Color 8-Pin Connector Signal Name

Figure 3–22 Cable, Fiber Optic, Armored, 250 m (60-0026)

Figure 3–23 Mast (55-0050)