User's Manual

76 RT System 2 v2.3 Deployment Guide R01.i

4. Point-to-Point Backhaul

Create Plan and Map

11 Click Apply.

12 The radio reboots and obtains a new IP address if a DHCP server is active. The current

session of airOS is no longer valid since the IP address of the radio has changed.

13 Close the browser window.

14 Disconnect the radio. It is now ready for deployment.

15 Continue connecting radios and uploading configuration files until they are all configured.

4.3 Create Plan and Map

Using the documents provided for the job (survey, planned LIU locations, and so on), create

a plan to plot radio locations and map the layout of AP and S radios.

Keep the following in mind as you create the layout plan:

i Point the radio pairs directly at each other whenever possible maintaining line-of-sight

around obstructions (see “Maintain Line-of-Sight” on page 77).

Figure 4–13 Ubiquiti, Apply Configuration Changes

NOTE

Radios were labeled prior to shipment and there should be a 1:1 correlation

between radios and configuration files. Make sure the correct configuration file is

loaded onto the corresponding radio.

Figure 4–14 Create Plan and

Map Troubleshooting Flow