User's Manual Part 1

RT System 2 v2.3 135 Deployment Guide R01.i
© 2010-2014 Wireless Seismic, Inc. All rights reserved.
6
6. Demobilization
6.1 Overview
This chapter describes how to prepare (undeploy) the ground electronics for transport at
the end of a project (demobilization).
6.2 Removing the WRU from the Field
This section describes the process to ready the WRU for movement to a new physical
location or to remove it in preparation for demobilization.
To undeploy the WRU:
1 Prerequisites:
Ɣ The WRU is assembled with battery, geophone, optional anchor plate, and
antenna (and extender)
Ɣ The WRU is in an active, transitional, or ready state
2 Optional: If the anchor plate is attached, remove the nails or stakes anchoring it to
the ground.
3 Pick up the WRU and point the geophone connector end towards the sky as shown in
the following figure. Within a few seconds, all of the LEDs illuminate:
Figure 6–1 Power Off the Unit