User's Manual

Draft
RT System 2 v2.0.0 81 Deployment Guide R00.e
© 2010-2012 Wireless Seismic, Inc. All rights reserved.
A
A. Legal Information
A.1 FCC Rules and Regulations Compliance
The Federal Communications Commission (FCC) regulates the use of antennas
in the “Code of Federal Regulations – Title 47, Part 15 – Radio Frequency
Devices, Subpart C – Intentional Radiators, Section 15.203 Antenna
Requirement.”
When used as intended, the RT System 2 complies with FCC Section 15.203
requirements as follows:
 The RT System 2 antennas shall be installed and handled by professionals
specifically designated for this purpose.
 Changes or modifications not expressly approved by Wireless Seismic, Inc.
can void the users’s authority to operate the equipment.
 The RT System 2 shall be used with only the supplied antennas (Table A–1)
attached to the WRU or LIU with an integrated type N male connector.
NOTE
This equipment has been tested and found to comply with the limits for
a Class A digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
Table A–1 Antenna Specifications
Model
Frequency
(MHz)
Gain
Vertical
Bandwidth
Weight
Dimension
(Length x
Diameter)
WSI 65-0067 2400-2485 9 dbi 14° 0.8 lbs
0.5 kg
27 x 0.6 in
690 x 15 mm
WSI 6060-001-01 2400-2485 7 dBi 18° 0.6 lbs
0.3 kg
21 x 0.6 in
540 x 15 mm
WSI 65-0023 2400-2485 5 dBi 25º 0.5 lbs
0.2 kg
12 x 0.6 in
355 x 15 mm
WSI 65-0025 2400-2485 2 dBi @ 2.4 120° 1.6 oz
45.4 g
7.6 x 0.5 in
193 x 12.7 mm