User's Manual

Draft
R00.e RT System 2 v2.0.0 Deployment Guide 93
© 2010-2012 Wireless Seismic, Inc. All rights reserved.
D. LED Indicators
Once the power on sequence is complete, the LED indicators in the following table
can be seen.
Table D–2 WRU LED Status Indications
LED Indicators Summary Description
Undeployed
Standby
Armed
Dead Batteries
If no LEDs are on (lit up), it can be one of the
following scenarios:
• Unit Undeployed
• Unit in Standby mode
• Unit in Armed mode
• Batteries dead
When you do a tilt test on a unit with no LEDs
on, the following may occur:
• An Undeployed unit deploys and begins
the self tests
• A unit in Standby mode displays an LED
error condition
• A unit in Armed mode will continue to
display no lit LEDs
• A unit with dead batteries will continue to
display no lit LEDs
NOTE: Battery state is shown in the
RT System 2 user interface tables. For
example, the Ground Equipment
Table.
Geo Down Tilt Detected All LEDs are on solid
Battery test in progress Flashing:
•MODE
•BAT
Battery A in use A flashing
Self test in progress Flashing:
•MODE
•BAT
•GEO
•GPS
•RAD