User's Manual

Draft

R00.e RT System 2 v2.0.0 Deployment Guide 99

E. Weighted Mast

Hardware Supplied

E.2 Hardware Supplied

The following hardware is supplied with the tripod mast:

 4 - Bolt, Carriage 1/4 - 20 x 3/4"

 12 - Bolt, Carriage 1/4 - 20 x 5/8"

 4 - Bolt, 1/4 - 20 x 3/4" Hex Head

 4- Bolt, 1/4 - 20 x 1/2" Hex Head

 24-Nut, 1/4 - 20

 24 - Lock washer, 1/4 Int. tooth

E.3 Assembly Instructions

This section provides instructions and illustrations for assembly of the tripod.

To assemble the tripod:

1 Assemble one 244 Flange to the Center Support Plate using four 1/4-20 x 3/4"

carriage Bolts, Lock washers and Hex Nuts. Make sure to assemble the Bolts

with the Heads on the underside of the frame. Hex Nut should be on the top

side of the frame.

2 Assemble Base Frame and Center Support Plate using twelve 1/4-20 x 5/8"

carriage Bolts, Lock washers and Hex Nuts. Make sure to assemble the Bolts

with the Heads on the underside of the frame. Hex Nut should be on the top

side of the frame.

3 Assemble the four (4) Braces to the upper support flange using four 1/4-20x3/

4 Hex Head Bolts, Lock washers and Nuts.

Figure E–2 Tripod Assembly – Front View