Installation Manual

6
CONFIDENTIAL UNDER NON-DISCLOSURE AGREEMENT (NDA)
Rev A1
Document:
WSS 4G Aircraft Installation Manual 750-
00003-00 Reva1.Docx
July -30
2020
HPB/FDQ Circular Antenna Connectors
2
Mil Circular Connector (Mates with MIL-DTL-
26482 Series 1, C58-533723-10P for FDQ
and HPB Antennas)
MIL-C-26482 Series I, Size 12, Insert 12-
10, with 10 ea. #20 socket contacts.
Ex: Amphenol PT06SE-12-10S (crimp)
2
M85049/8x-12xxx EMI Backshell for Size 12
Mil Circular Connector (Straight or angled)
M85049/8x-12xxx EMI Backshell
Isodyne: ISODJ150NF1202-S EMI
Backshell 90° or equivalent
FDQ/HPB Antenna Gasket
1
Av-deHi-Tak Polyurethane Conductive HPB
Gasket
AG247000-35
1
Av-deHi-Tak Polyurethane Conductive FDQ
Gasket
AG924000-09
Wire Harness Insulation and Sleeving (quantity as required)
A/R
Insulation Sleeving (.375)
M23053/4-104-0 or equivalent
A/R
Insulation Sleeving (.500-.195DIA)
M23053/4-105-0 or equivalent
A/R
Insulation Sleeving (.750- .313)
M23053/4-106-0 or equivalent
A/R
Insulation Sleeving (.063- .031)
M23053/5-102-0 or equivalent
A/R
Tubular Braid Wire 0.500-inch diameter
AA59569R36T0500 or equivalent
1.6 Interface Summary
The WSS 4G System requires multiple RF, power and control cable connections.
Figure 1.6-1 shows the basic system, and a simplified aircraft cabling diagram. In
addition to the radio-antenna cables, connection to the aircraft +28 V
DC
power bus is
required.
Figure 1.6-1 System Interfaces / Overview