Installation Manual

25
CONFIDENTIAL UNDER NON-DISCLOSURE AGREEMENT (NDA)
Rev A1
Document:
WSS 4G Aircraft Installation Manual 750-
00003-00 Reva1.Docx
July -30
2020
FDQ
(PN AT2450-2)
HPB
(PN AT2450-5)
Figure 3.5.1-2 Reverse Antenna Mounting Configuration
Once the antenna locations have been identified, determine the cable length required
between the mounted ABR chassis, and the antenna fixtures. Select the appropriate
cable to use based upon the guidance in Section 3.6.4.
3.5.1.1 WSS Antenna Site Selection and Separation
WSS provides dedicated engineering resources to work with the installer in the
antenna placement process on all STC projects. WSS’s cutting edge modeling tools
provide insight into the antenna performance as mounted on a particular aircraft
model. The below guidelines provide generic guidance on antenna placement;
however, the actual antenna location per airframe will be determined through a joint
effort of WSS and the STC partner.
Consideration should be given to mount the antenna in a location that provides the best
performance versus accessibility to mounting of the antenna. Figures 3.5.1-2 and 3.5.1-
3 show installations on representative aircraft to provide best performance; areas
indicated in Green are permissible areas to mount antennas; areas indicated in Red
should be avoided.