Installation Manual

47
CONFIDENTIAL UNDER NON-DISCLOSURE AGREEMENT (NDA)
Rev A1
Document:
WSS 4G Aircraft Installation Manual 750-
00003-00 Reva1.Docx
July -30
2020
5.2 Connector Parts Lists and Construction
The following provides guidance on the specific parts and connector make up that
should be observed when constructing the cables for the ABR and antennas.
5.2.1 ABR Power Input (P1-A)
The P1-A connection is used for aircraft power to the ABR.
Table 5.2.1-1 P1-A Parts List
Quantity
Manufacturer & Description
Part Number
Drawing Item
Number (IN)
A/R
Power Cable 14 AWG, Single
Conductor
M27500-14TG2T14 or
equivalent
11
2
TE Connectivity
Solder Sleeve (.275IDXx .750LG)
M83519/1-5
19
1
TE Connectivity/Deutsch DMC
Chimney
732-8052-18A
7
2
GlenAir
Tie-down Strap
600-057 or equivalent
8
1
Braid Wire (36AWG, .500DIA)
AA59569R36T0500 or
equivalent
17
A/R
Insulation Sleeving (.375DIA)
M23053/4-104-0 or equivalent
27
A/R
Insulation Sleeving (.500-.195DIA)
M23053/4-105-0 or equivalent
28
A/R
Insulation Sleeving (.750- .313)
M23053/4-106-0 or equivalent
29
A/R
Power Cable, 2 COND
To be determined by installer
16
Figure 5.2.1-1 P1-A Shield Terminations