Specifications

Page 79
WT1231H
A
9. Ordering Information
WT1231H—433 S2
P/N: WT1231H-315S2
WT1231H module at 315MHz band, SMD
Package P/N: WT1231H-433S2
WT1231H module at 433MHz band, SMD
Package P/N: WT1231H-868S2
WT1231H module at 868MHz band, SMD
Package P/N: WT1231H-915S2
WT1231H module at 915MHz band, SMD Package
V
Package
O
p
eration Ban
d
Mode Type
Receiver category: Category 2 is standard performance level of receiver.
This device is intended only for OEM integrators under the following conditions:
1)The transmitter module may not be co-located with other transmitter or antenna, with antenna gain less 0dbi.
2)
For all products market in US, OEM has to limit the operation channels in 433MHz
by supplied firmware programming tool. OEM shall not supply any tool or info to
the end-user regarding to Regulatory Domain change. As long as 2 conditions above
are met, further transmitter test will not be required. However, the OEM integrator is
still responsible for testing their end-product for any additional compliance
requirements required with this module installed
The host will Satisfy Class I or Class Ⅱ permissive change based this module FCC ID.
If the FCC identification number is not visible when the module is installed inside the host, then
the outside of the device into which the module is installed must also display a label referring to
the enclosed module. This exterior label can use wording such as the following: “Contains
Transmitter Module Contains FCC ID:2AFOSWT1231H-433 or “Contains FCC ID:2AFOSWT1231H-433
.Any similar wording that expresses the same meaning may be used.