Installation Manual

Step 4 Push Poke-Thru into floor. Step 5 Installation complete.

For Flush Tile Installation (Start with Steps 1 & 2 on previous page.)

Step 3 Place shims around bottom of flange to

match thickness of tile. Flange is 1/8"

thick. (2) 1/8" shims and (2) 1/16" shims

are provided. Push Poke-Thru into floor.

Step 4 Use grout and/or silicone caulk

between edges of flange and tile.

NOTE: If more shims are required, use Cat. No 6TS.

Step 1 Insert Stem Assembly into core hole.

INSTALLING STEM ASSEMBLY AND SEPARATE COVER

Step 2 Remove disposable plate and (2) plate clips by

removing the 8-32 screws. Install Flange using

the (2) 8-32 x 1/2" Cap Head screws provided

with the cover assembly.