Installation Manual

AL3311 90° FLAT ELBOW AL3317 INTERNAL ELBOW
AL3315 TEE FITTING
AL3318 EXTERNAL ELBOW
AL3300WC WIRE CLIP
At 90° turn , position AL3311 Flat Elbow at end of AL3300B
base. Position next bases section onto other end of AL3311.
Center couplings over base joints and tighten screws.
Install fitting cover after wiring.
Install AL3317 to raceway base BEFORE mounting raceway
base. Fasten base section to surface joints, tighten
setscrews. Install fitting cover after wiring.
AL3315 Tee Fitting, position fitting at end of AL3300B base.
Install other base section to other end of fitting. Center
couplings on joints and tighten screws. Install fitting
cover after wiring.
At 90° outside corner, position AL3318 External Elbow at end
of the fitting. Center couplings on joints and tighten screws.
Install fitting cover after wiring.
For retaining wires in long raceway runs, snap-in AL3300WC
Wire Clip approx. 30" apart into AL3300B Base.
Wiremold / Legrand
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX [phone] • Outside U.S. 860-233-6251
Canada:
570 Applewood Crescent • Vaughan, Ontario L4K 4B4
1-800-723-5175 • FAX [phone]
INST014 R2 – Updated April 2005 – For latest specs visit www.wiremold.com
© Copyright 2005 The Wiremold Company All Rights Reserved
AL3316 CROSS FITTING
AL3316 cross Fitting, position fitting at end of AL3300B base.
Install other base sections to other ends of the fitting. Center
couplings on joints and tighten screws. Install fitting cover
after wiring.