Installation Manual

ALA3800B Base
(ALA3810B shown)
3/4" [19.1mm] Conduit
1/2" [12.7mm] Conduit
End-feeding: ALA3810B1 Series End Fittings
have concentric 1/2" [12.7mm] and 3/4"
[19.1mm] trade size KOs in end. Provide
electrical feed through KOs. Insert fitting into
end of raceway base. Secure in place by
tightening two screws.
3
4
6
5
1
2
1 - Provide electrical feed through the concentric 1/2" [12.7mm]
and 3/4" [19.1mm] KO in ALA3810B1 End Cap.
2 - Attach base section to mounting surface by drilling
9/32" [7.14mm] holes in the base then fastening with
#8 flat head screws.
3 - Secure conductors in place with ALAWC Wire Clip.
4 - Join additional raceway sections with an ALA01 Coupling.
5 - Close ends with ALA3810B1 End Caps.
6 - Snap ALAC-5 Cover into ALA3800B-10 Base to
complete installation.
To attach ALA3800B-10 Series Base sections to mounting
surface; drill 9/32" [7.14mm] holes in the base (approx.
18" [457mm] O.C.). Fasten Base with #8 flat head screws.
18"
[457mm]
At end of ALA3800B-10 Raceway
run: slide ALA3810B Blank End
Fitting in last base section. Secure in
place by tightening two screws.
ALA01
ALA3800B-10
Base Sections
At ALA3800B-10 Base section butt joints: slide an ALA01
Coupling into first base section. Mount next base to surface.
Center coupling on joint. Tighten locking screws.
Position ALA09 Ground Clamp
into ribs in ALA3800B-10 Base.
Fasten mounting screw. Attach
ground wire using brass cup
washer & green hex nut to
ground lug.
At 90° turn on same surface, position ALA3811 Flat Elbow at end of
ALA3800B-10 Base. Position next base section onto other end of ALA3811.
Center coupling over base joint and tighten screws. Install ALA3811 Covers
and ALA3800 Series Covers as shown after wiring.
For connecting a vertical run of
ALA3800B-10 Base with a horizontal
overhead run with its cover facing up.
Assemble ALA3817N to raceway bases
with ALA01 Couplings included.
Install one side of ALA17A Internal Coupling,
BEFORE mounting raceway base. Fasten first base sec-
tion to wall, then slide adjoining base onto coupling
legs. Tighten all coupling screws.
Install ALA3817 to first raceway base, BEFORE mount-
ing raceway base. Fasten base section to surface. Butt
next section of base. Center couplings over base joints,
tighten set screws.
ALA3811
ALA3811 With Cover
ALA17A Internal Corner Coupling
ALA3817 Internal Elbow
Options for 90° Internal Corners:
System Layout
ALA3817N