Installation Manual

ManualsBrandsWiremold Manuals& CouplingsSeam Clip Fitting, DS4000 Series, Steel, White

DS4000 Raceway

Base & Cover

INSTALLATION INSTRUCTIONS

Installation Instruction No.: 43324 – December 2005

Wiremold / Legrand Electrical Systems conform to and should be

installed and properly grounded in compliance with requirements

of the current National Electrical Code, Canadian Electrical

Code, or codes administered by local authorities.

All electrical products may represent possible shock or fire

hazard if improperly installed or used. Wiremold electrical

products are UL listed to U.S. and Canadian safety

standards, made for interior use only, and should be installed

in conformance with current local and/or the National

Electrical Code.

Step 1. If the installation requires Fittings,

start at an appropriate location

such as a corner. Refer to specific

fitting installation instructions for

proper mounting.

Step 3. Butt succeeding DS4000 Base Sections

tightly to installed base in order to

maintain hole alignment. Slide Couplings

into place and tighten.

NOTE: Raceway Base includes Couplings and Wire Clips. Wire Clips are factory installed in the

lower channel of each Raceway Base section. Make sure base sections are properly

oriented prior to securing to the wall.

Products Covered: DS4000B, DS4000C.

Step 2. Leaving Coupling loose, mate DS4000 Base section to installed

Fitting. Using up to 4" [102mm] of lateral adjustment provided by

Couplings, align Mounting Hole with Wall Stud. Secure to wall using

#8 Fasteners 48" [1.2m] apart. Tighten Coupling Screws.

For more information, visit www.wiremold.com/ds4000.

Maximum

4" [102mm]

adjustment

Stud Location

Adjust-to-Fit™

Couplings

Summary of content (4 pages)

PAGE 1
Wiremold / Legrand Electrical Systems conform to and should be installed and properly grounded in compliance with requirements of the current National Electrical Code, Canadian Electrical Code, or codes administered by local authorities. All electrical products may represent possible shock or fire hazard if improperly installed or used. Wiremold electrical products are UL listed to U.S.
PAGE 2
Step 4. Install the next fitting. Measure and cut DS4000 Base at the closest score short of the fitting. Install DS4000 Base and tighten Coupling screws. Cut Here Use scores on DS4000 Raceway Base to make cuts – Snip where shown and bend along scored line to break. Wire Clip Installation – Additional Wire Clips are provided for the upper channel of the Raceway. Hook Rotate clip and snap into place. Wire Ties can be added if desired.
PAGE 3
DS4000C Cover Installation: Step 1. Step 2. Hook Cover into Base Section. Installation Complete. Snap Cover into place to complete installation. DS4000C Cover Removal All Fittings and Activation Covers/Faceplates overlap the DS4000C Raceway Cover. To remove Raceway Cover Sections, first remove the Fitting or Faceplate (see specific fitting instructions) and then unsnap Raceway Cover Sections from Raceway Base as shown below. DS4006 Seam Clip Step 1. Step 2.
PAGE 4
For more information, visit www.wiremold.com/DS4000. Wiremold / Legrand U.S. and International: 60 Woodlawn Street • West Hartford, CT 06110 1-800-621-0049 • FAX 860-232-2062 • Outside U.S. 860-233-6251 Canada: 570 Applewood Crescent • Vaughan, Ontario L4K 4B4 1-800-723-5175 • FAX 905-738-9721 © Copyright 2005 Wiremold / Legrand All Rights Reserved 43324 – December 2005 – For latest specs visit www.wiremold.