Installation Manual

DS4000C Cover Installation:
Step 1.
Step 2.
DS4000C Cover Removal
Hook Cover into Base Section. Installation Complete.
All Fittings and Activation Covers/Faceplates overlap the
DS4000C Raceway Cover. To remove Raceway Cover
Sections, first remove the Fitting or Faceplate (see
specific fitting instructions) and then unsnap Raceway
Cover Sections from Raceway Base as shown below.
Snap Cover into place to complete installation.
DS4006 Seam Clip
Step 1.
Step 2.
The DS4006 Seam Clip is used to cover the cut edge of a
cover section. Make sure any gaps between raceway Covers
are less than 1/16" [1.5mm].
Installation Complete.