Cut Sheet

6”
Catalog No./Item Description/Specifications
“A”
Reducer Coupling – Used to reduce Wallduct
WD350-RO2 2" [51mm] width by 4" [102mm] or 8" [204mm]. Two piece
WD350-RO4 4" [102mm] unit allows 18" [457mm] wide Wallduct to be
reduced to 10" [254mm] wide, or 10" {254mm]
wide to be reduced to 6" [152mm] wide. Can also
be used on other sizes as needed. Assembly
screws included.
“A” Cabinet Connector/Drop Out – Used to connect
WD06W350-CC/DO 5 3/4" [146mm] ends of Wallduct run to panel/cabinet. Also used
WD10W350-CC/DO 9 3/4" [247mm] to connect two runs of Wallduct at a 90° angle
WD18W350-CC/DO 17 3/4" [450mm] when one run butts up to the bottom or top of the
other. Assembly screws included.
“A” Sweep Cabinet Connector – For use
WD06W350-SWCCS 6" [152mm] with GE medical equipment. Attaches to 6" x
WD10W350-SWCCS 10" [254mm] 3 1/2" [152mm x 89mm], 10" x 3 1/2" [254mm x
WD18W350-SWCCS 18" [457mm] 89mm], or 18" x 3 1/2" [457mm x 89mm]
horizontal surface Wallduct.
NOTE: Not available in aluminum.
“A” “B” Transition – Used to form a junction between
WD06W350-FST 6" [152mm] 8" [203mm] flush and surface Wallduct at a 90° angle.
WD10W350-FST 10" [254mm] 12" [304mm] Includes assembly screws, clips, one wire
WD18W350-FST 18" [457mm] 20" [508mm] retainer and two coupling angles.
8
A
2 1⁄2"
[64mm]
10 1⁄2"
[266mm]
8"
[203mm]
Wallduct Accessories
A
3 1⁄4"
[82mm]
1"
25mm]
A
1"
[25mm]
B
Duct Body Surface
Cover Plate
Duct Body Flush
NOTE: To order aluminum products, add the letter “A” to the beginning of the catalog number.
A
A