User manual

Figure II.7 Status after Turning on the PMB5010

11. Within 5 seconds (start counting when you turn on the PMB5010), you should click the

“Open” button on the Hyper-terminal popup window. Firmware download will then start. If

you fail to start the download within this period of time, the original firmware on PMB5010

will automatically start. You have to turn off the PMB5010, and repeat the download

procedure again from Step 2

12. When the download is started, you will see the following text. At the end, “Firmware Update

Successfully!” will be shown if the download succeeds. The whole process will take about 1

minute

Figure II.8 Successful PMB5010 Firmware Upgrade

13. When the download is finished, you could disconnect the COM connection in the hyper-

terminal, and re-start your PMB5010