User manual

Server configuration menu.

Set the IP Address

If DHCP is not used to assign IP addresses, enter it manually. The IP address must be set to a

unique value in the network. Enter each octet and press Enter between each section inputted.

The current value is displayed in parentheses.

IP Address : ( 0) ( 0) ( 0) ( 0)

Set the Gateway IP Address

The gateway address, or router, allows communication to other LAN segments. The

gateway address should be the IP address of the router connected to the same LAN

segment as the unit. The gateway address must be within the local network.

The default is N (No), indicating the gateway address has not been set. To set the gateway

address, type Y. At the prompt, enter the gateway address.

Set Gateway IP Address (N) ? Y

Gateway IP addr ( 0) ( 0) ( 0) ( 0)

Set the Netmask

A netmask defines the number of bits taken from the IP address that are assigned for the

host part.

Netmask: Number of Bits for Host Part (0=default) (0)

The unit prompts for the number of host bits to be entered, then calculates the netmask, which

displays in standard decimal-dot notation when the saved parameters are displayed (for

example, 255.255.255.0).

Table IV.4 Standard IP Network Netmasks Representing Host Bits

Network Class Host Bits Netmask

A 24 255.0.0.0

B 16 255.255.0.0

C 8 255.255.255.0

Change Telnet Configuration Password

Setting the Telnet configuration password prevents unauthorized access to the setup

menu via a Telnet connection to port 9999 or via web pages. The password must have

4 characters.

Change telnet config password (N) ?

An enhanced password setting (for Telnet access only) of 16 characters is available under

option 6 Security from the Change Setup menu.

Note: A password is not required to access the Setup Mode window via a serial