User manual

Copyright © Dr Robot Inc. 2006
103
With modem_control_in Active 0 0 1 0
With a specific start character 0 0 1 1
Manual connection 0 1 0 0
Autostart 0 1 0 1
Hostlist 0 0 1 0
d) Datagram Type
Directed UDP 1 1 0 0
e) Modem Mode
Full Verbose 1 0 1 1 0
Without Echo 0 0 1 1 0
Numeric modem result codes 1 0 1 1 1
a) Incoming Connection
Never Accept Incoming Rejects all external connection attempts
Accept with modem_control_in Active Accepts external connection requests only
when the modem_control_in input is asserted.
Cannot be used with Modem Mode
Always Accept Accepts any incoming connection when a
connection is not already established. Default
setting
b) Response
Character Response A single character is transmitted to the serial port when there
is a change in connection state:
C = connected, D = disconnected, N = host unreachable.
This option is overridden when the Active Start Modem Mode
or Active Start Host List is in effect. Default setting is
Nothing (quiet).
No Active Startup Does not attempt to initiate a connection. Default setting
With Any Character Attempts to connect when any character is received from the
serial port
Accept with
modem_control_in
Active
Attempts to connect when the modem_control_in input
changes from not asserted to asserted
With a Specific Start
Character
Attempts to connect when it receives a specific start character
from the serial port. The default start character is carriage
return
Manual Connection Attempts to connect when directed by a command string
received from the serial port. The first character of the
command string must be a C (ASCII 0x43), and the last
character must be either a carriage return (ASCII 0x0D) or a
line feed (0x0A). No blanks or space characters may be in the
command string. Between the first and last command string
characters must be a full or partial destination IP address and