User manual

Copyright © Dr Robot Inc. 2006
108
does not recognize compound commands such as ATE0V.
Remote IP Address
This is the destination IP address used with an outgoing connection. The current value is
displayed in parentheses.
Remote IP Address : ( 0) ( 0) ( 0) ( 0)
Note: This option is not displayed when Hostlist is enabled from the ConnectMode
prompt
Remote Port
Set the remote TCP port number for the unit to make outgoing connections. This
parameter defines the port number on the target host to which a connection is
attempted.
To connect an ASCII terminal to a host using the unit for login purposes, use the remote port
number 23 (Internet standard port number for Telnet services)
Remote Port ( 0) ?
Note: This option is not displayed when Hostlist is enabled from the ConnectMode
prompt
DisConnMode
Disconnect Mode (DisConnMode) determines the conditions under which the unit will cause a
network connection to terminate. The current value is displayed in parentheses.
DisConnMode ( 0) ?
In DisConnMode, modem_control_in either drops the connection or is ignored. The
following table displays the available input options:
Table IV.13 Disconnect Mode Options
Disconnect Mode Option 7 6 5 4 3 2 1 0
Disconnect with
modem_control_in drop
(6)
1
Ignore modem_control_in 0
Telnet mode and terminal type
setup
(1)
1
Channel (port) password
(2)
1
Hard disconnect
(3)
0
Disable hard disconnect 1
State LED off with connection
(4)
1
Disconnect with EOT (^D)
(5)
1
(1) The WFS802b sends the "Terminal Type" upon an outgoing connection.
(2) A password is required for a connection to the serial port from the network.
(3) The TCP connection closes even if the remote site does not acknowledge the
disconnection.
(4) When there is a network connection to or from the serial port, the state LED turns off