User manual

Copyright © Dr Robot Inc. 2006
114
protecting Telnet access.
Disable Port 77F0 (Hex)
Port 77F0 is a setting that allows a custom application to query or set the eleven
WFS802b configurable pins when they are functioning as general purpose I/O (GPIO).
Disable this capability, if desired, for security purposes.
Disable Port 77F0h ?
The default setting, the N (No) option, enables GPIO control. The Y (Yes) option
disables the GPIO control interface.
IV.5.8
Factory Defaults
Select 7 Factory Defaults from the Change Setup menu to reset the unit’s Channel 1
configuration, Channel 2 configuration, E-mail settings, and Expert settings to the factory
default settings. The server configuration settings for IP address, gateway IP address, and
netmask remain unchanged. The configurable pins’ settings also remain unchanged. The
specific settings that this option changes are listed below:
Channel 1 Configuration
Baudrate 9600
I/F Mode 4C (1 stop bit, no parity, 8 bit, RS-232C)
Port No 10001
Connect Mode C0 (always accept incoming connection; no
active connection startup)
Hostlist Retry Counter 3
Hostlist Retry Timeout 250 (msec)
Send Character 0x0D (CR)
All other parameters 0
Channel 2 Configuration
Baudrate 9600
I/F Mode 4C (1 stop bit, no parity, 8 bit, RS-232C)
Port No 10002
Connect Mode C0 (always accept incoming connection; no
active connection startup)
Hostlist Retry Counter 3
Hostlist Retry Timeout 250 (msec)
Send Character 0x0D (CR)
All other parameters 0
WLAN Settings
Enable WLAN (Y) Yes
Find Network Name LTRX_IBSS
Enable Ad Hoc Network Creation (Y) Yes