User manual

Copyright © Dr Robot Inc. 2006
118
1. Click Network from the main menu.
2. Select Use the following IP configuration.
3. Enter the following (as necessary):
IP Address If DHCP is not used to assign IP addresses, enter it manually. The IP
address must be set to a unique value in the network.
Subnet Mask A subnet mask defines the number of bits taken from the IP address
that are assigned for the host part.
Default Gateway The gateway address, or router, allows communication to other LAN
segments. The gateway address should be the IP address of the router
connected to the same LAN segment as the unit. The gateway address
must be within the local network.
4. Click the OK button when finished.
IV.6.3 Server Configuration
The unit’s server values display upon selecting Server from the main menu. The
following sections describe the configurable parameters within the Server configuration
menu.
Figure IV.3 Server Settings
To configure the WFS802b’s device server settings:
1. Click Server from the main menu.
2. Configure or modify the following fields:
Server Configuration
Telnet Password Enter the password required for Telnet access.
Retype Password Re-enter the password required for Telnet access.
Advanced
ARP Cache
Timeout
When the unit communicates with another device on the network, it
adds an entry into its ARP table. ARP Cache timeout defines the
number of seconds (1-600) before it refreshes this table.
TCP Keepalive TCP Keepalive time defines how many seconds the unit waits during