User manual

short timePeriod; // Executing time in milliseconds

Return value: void

Remarks:

1. All channel (motors) will be enabled automatically by the system when this

command is received

2. Target pulse width value range is 0 to 32767 (0x7FFF), corresponding to the duty

cycle of 0 to 100% linearly.

3. A pulse width value of 16363 means 50% duty cycle, putting motor in “Stop” stage.

Any value in between 16364 - 32767 will put the motor to turn clockwise (facing

the front side of the motor) and any value in between 0 – 16362 will put the motor

to turn counter-clockwise.

4. When some motors are not under controlled, their command values should be set as

-32768 (0x8000). That means NO_CONTROL.

See also: DcMotorPwmTimeCtr

103 void DcMotorPwmNonTimeCtrAll(short cmd1, short cmd2, short cmd3, short cmd4,

short cmd5, short cmd6);

Description:

DcMotorPwmNonTimeCtrAll sends the PWM control command to all 6 DC motor control

channels on the Sensing and Motion Controller (PMS5005) at the same time. The command

includes the target PWM values without specific execution time period. The motion

controller Send the desired PWM pulse width right away.

Syntax: DcMotorPwmNonTimeCtrAll (cmd1, cmd2, cmd3, cmd4, cmd5, cmd6);

Parameter: short cmd1; // Target PWM value for channel #1

short cmd2; // Target PWM value for channel #2

short cmd3; // Target PWM value for channel #3

short cmd4; // Target PWM value for channel #4

short cmd5; // Target PWM value for channel #5

short cmd6; // Target PWM value for channel #6