User manual

IV.5 Configuration via Serial Mode or Telnet Port

Configure the unit so that it can communicate on a network with your serial device.

The WFS802b unit is configurable using a terminal program to access the serial port locally. Using this

terminal program to respond to prompts is referred to as the Setup Mode. A Telnet connection may also be

used to configure the unit over the network.

The unit’s configuration is stored in nonvolatile memory and is retained without power. You can change the

configuration at any time. The unit performs a reset after the configuration has been changed and stored.

Note: The menus in this section show a typical device. Not all devices display information in the same

manner.

This chapter includes the following topics:

. Accessi

ng Setup Mode

. Server

Configuration

. Ch

annel 1 and Channel 2 Configuration

. Email

Configuration

WLAN Settings

. Ex

pert Settings

. Securi

ty Settings

Factory Defaults

. Exit

Configuration Mode

Figure IV.1 Connection WFS802b with MCR3210P RS232 Interface Module

IV.5.1

Accessing Setup Mode

Telnet Access

To configure the unit over the network, establish a Telnet connection to port 9999:

1. From the Windows Start menu, click Run.

2. From the Run dialogue box, type the following command (where x.x.x.x is the IP