User guide

15
system does not require unusually high torque on the screws to be
secure.
7. Paint the bezel and grill as necessary, being careful not to plug
up the holes in the grille. Note that the speaker modules are not
mounted in the bezel and grille assembly at this time. They can
be mounted later, after all the paint is dry.
8. Using assistance to hold the speaker modules away from the wall,
connect both high and low pass speaker cables to the two con-
nectors at the ends of the back boxes, paying attention to assign
the correct band-pass and polarity to their respective speaker
connectors.
9. Insert the speaker/back box assembly into the Uni-Grip frame and
attach using the supplied Allen head screws and 3/32” drill bit.
Do not over torque or strip these screws.