Installation Guide
Measure and mark the location of each hole with
a ruler or tape measure. Check that the holes are
level.
Drill holes at each mark.
*For best accuracy, drill slowly and apply light
pressure.
Align holes on hardware with the drilled
holes and secure with screws.
If you have any questions about how to install your hardware, please call us directly at (800) 464-7491
or (310) 374-5700 (for outside of USA) or contact us at support@wisdom-stone.com.
Cabinet Hardware Installation Instructions
(800) 464-7491 Outside US Call (310) 374-5700 www.wisdom-stone.com Wisdom-Stone is a division of Architectural Mailboxes LLC, Redondo Beach, CA 90277
1
2
3
4
!
DO NOT overtighten.
Recommended Tools
(not included)
3/16” Drill bit
#2 Phillips screwdriver
Power drill
Pencil
Ruler
HARDWARE
-or-
Tape Measure
(2) #8-32 screws, 1” length
(2) #8-32 screws, 1.5” length
(1) #8-32 screws, 1” length
(1) #8-32 screws, 1.5” length
For Knobs
For Pulls
© 2018, Wisdom-Stone Rev A
Locate area of installation.
*For pulls, measure the center to center hole
distance.