Owner's Manual

English _11
installation
4. Fix the bracket with the HDD to the recorder with screws.
5. Connect the SATA/power cable of the HDD to the connector on
the motherboard.
Refer to the figure below for the location/connector number of
the HDD.
2
1
4
3
6
5
8
7
1
2
3
4
5
6
7
8
6. After making sure that there is no problem with the connection
terminal and wiring inside the product, close the cover and fix it
with screws.
How to install an HDD in HRX-1634
1. Loosen the screws on the left/right sides and back and slide the
cover back to remove it.
2. Connect the SATA/power cable of the HDD to the connector on
the motherboard.
3. Fix the HDD to the bottom of the recorder with screws.
4. Check if there is any problem with the connection terminal and
wiring inside the product.
5. Close the cover and secure it with screws.