Owner's Manual

12_ connecting with other device
connecting with other device
CONNECTING TO AN EXTERNAL DEVICE
■
The following figures are based on Model HRX-1635.
VIDEO OUT
(VGA)
AUDIO OUT
HDMI OUT
■
Unrated or improper power source may cause damage to the system. Ensure that you use only the rated power source before pressing the
POWER button.
CONNECTING THE USB
1. On the front of the product, there is a USB port.
2. You can connect a USB HDD, USB memory or mouse to the USB port.
3. If your USB HDD is connected to the system, it can be detected and set up by following the steps in “Setup >
Setting the Device > Storage Device” of the Wisenet Recorder User Manual.
4. The product supports hot plugging function that enables connecting/disconnecting USB devices while in
operating the system.
■
If you use the USB device for Backup purposes, format it with FAT32 on PC if it is not formatted on the Recorder.
■
Some USB devices may fail to function properly due to compatibility issue, please check the device before using.
■
Only USB storage devices that comply with the standards (having a metal cover) are guaranteed for data transfer.
■
In case if the USB device’s electric contacts have been worn out, data transfer between the devices may not properly function.
CONNECTING THE ALARM INPUT/OUTPUT
The Alarm In/Out port at the back is composed of the following.
AC L1
DC -
DC +
AC L2
FG
DC +
GND
COM
NO
Alarm
Sensors
30VDC 2A, 125VAC 0.5A MAX
MAX DC18V, Typical DC12V, 2A
●
ALARM IN : Alarm Input Port
●
ALARM OUT : Alarm Output Port
N.O C N.C N.O C N.O C G1 2 3 4 G
1 2 3
ALARM OUT
(MAX DC30V, 2A ,
Typical DC12V, 2A)
ALARM IN
(5mA sink)
■
Do not connect the Alarm power (DC-) to the Ground signal (FG) of the Recorder.