User Manual

English _13

! STARTING

Registering using Device Manager

If the product is connected to a network which includes a computer where the device manager is installed, you

can search products, set up passwords, change IP addresses, upgrade firmware, and access web pages.

Please refer to the manual of the Device Manager Program for more information.

The Device Manager Program ( ) is available on the official Hanwha Techwinwebsite (http://www.hanwha-

security.com) by clicking <

Technical Support

> - <

Online Tool

1. When you connect the product to the switch hub, its IP address is 192.168.1.99, and its status

information is queried as <Need PW>.

2. Select one or multiple products and set a password to use for each product.

Set a password in the [Credential] menu and press [Search] on the list screen. Then, the status

information is queried as <Login Fail> or <Login OK>.

Depending on the number of products selected or the network conditions, you may encounter the

<Connect Fail> message. The password setting and [IP Assign] function will run normally irrespective

of the indicated status.

For the rest of the products that are queried as <Need PW>, select them and set passwords for them.

If they are not queried as <Need PW>, run <New Project>

;

<Search> and set the passwords after

being queried as <Need PW>.

A password should contain 8 or more characters, and if it contains fewer than 9 characters, then a combination of

3 or more English uppercase/lowercase letters, numbers, or special characters must be used. If it includes 10 to 16

characters, a combination of 2 or more types must be used.

It is recommended not to use the same character repeatedly or consecutive keyboard inputs as passwords for

enhanced security.

3. Select a product to set its IP address, and enter the IP address to use (e.g., Set Static IP).

When you select products one by one

Select <Assign the following IP address> from the [IP Assign] menu, then set its IP address.

The DNS server address is automatically set as the product’s initial DNS address (DNS1 8.8.8.8,

DNS28.8.4.4).

When you select multiple products

Select <Assign the following IP address> from the [IP Assign] menu. Then apply the starting address

in the range of IP addresses to be assigned.

When you select <

Obtain an IP address automatically (DHCP)

> from the [

IP Assign

] menu, the DHCP IP address

is automatically assigned.

The HTTP port supports only the number 80, and the VNP and RTSP ports are not used in the network audio

product.