User's Manual

Wisen Innovation Technical Doc. No.2021 WiSenMeshWAN® 4-Channel Vibrating Wire Interface Node - User Manual
www.wisencn.com Page - 10 - of 14
please use a handheld readout device to confirm valid readings can be read;
5) Sensor connections to Node:
A. Strip the cable sleeve back by 8mm;
B. The 5 wires from the cable are VW+, VW-, Thermistor (Temperature)+, Thermistor (Temperature)- and
Ground. Please refer to the sensor datasheet to identify the purpose of the stripped wires;
C. Untighten the gland cover, insert cable through the gland, then connect the 5 wires correspondingly as
shown in the Figure below;
D. Once the wires are connected, please tighten the gland cover firmly to ensure its IP rating on that channel.