User Manual Part 2

19
Additional Note for Windows NT4.0
The installation procedure under Windows NT4.0 will be slightly different
from the previous Windows 98SE installation shown.
1. Click “OK” and system will auto-select the I/O address and the IRQ,
and remind you to choose the unused I/O address and IRQ from
Windows NT Diagnosis to prevent system resource conflict.
2. If the Ndis 3.0 packet driver already exists in your system, the setup
message will be prompted as follows, just click “OK”.
3. A prompt of networking setting will appear as follows. It’s the same
as Windows 98SE operating system. Click “Yes” if you need to
install “Microsoft Network Protocols”. Refer to Section 7.2 “Microsoft
Network Checklist” for more details.