User Manual

13
In the new Select Network Protocol window, select
Microsoft in the Manufacturers area.
Step 5. In the Network Protocols area of the same window, select
TCP/IP, then click OK. You may need your Win95/98 CD
to complete the installation. After TCP/IP installation is
complete, go back to the Network window shown in Step 4.
Step 6. Select TCP/IP in the list of Network Components.
Step 7. Click Properties, and check the settings in each of the TCP/IP
Properties window:
Bindings Tab: both Client for Microsoft Networks
and File
and printer sharing for Microsoft Networks should be
selected.
Gateway Tab: All fields should be blank.
DNS Configuration Tab: Disable DNS
should be selected.
IP Address Tab: Obtain IP address automatically
should be
selected.
Step 8. With the 802.11G ACCESS POINT powered on, reboot the
PC/wireless client. After the PC/wireless client is re-booted,
you should be ready to configure the 802.11G ACCESS
POINT. See Chapter 3.
The procedure required to set a static IP address is not too much different from the procedure
required to set to “obtain IP addresses dynamically” - except that at the end of step 7, instead
of selecting “obtain IP addresses dynamically, you should specify the IP address explicitly.