User Manual

45
Command> show stp
STP is enabled
Show stp
Description: This command displays the STP setting. This information is also displayed in the
“show system” command.
Example:
Command> show stp
STP is enabled
Show bridge table
Description: This command shows all MAC entries in the bridge table, including those
learned from the LAN interface, wireless clients (that are associated with the 802.11G
ACCESS POINT), and WDS peers.
Example:
Command> show bridge table
MAC Address Interface
----------------------------------
00-01-02-03-04-05 LAN
00-05-04-03-02-01 WLAN
Total 2 entries
Clear config
Description: This command is used to clear the configuration data in the flash memory. After
clearing, the system will reboot. All user-configured data will be lost. The configuration will
return to the factory default settings.
Example:
Command> clear config
All configuration will be cleared and system will reset
Do you want to continue (y/n)? y
Save config
Description: This command saves any configuration changes to the flash memory.
Example:
Command> save config