User Manual

IEEE 802.11g Access Point User’s Guide
50
Command> set dhcp server
enter lower IP address of address pool (192.168.1.2):
enter upper IP address of address pool (192.168.1.254):
enter lease time (10080, 1 - 525600):
do you want to assign DNS server (Yes, yes/no)
/* if yes is entered */
enter IP address of the primary DNS (Unspecified): 129.1.1.1
enter IP address of the secondary DNS (Unspecified): 129.1.1.2
DHCP server status: Disabled
IP address range: 192.168.1.2 to 192.168.1.254
Network mask: 255.255.255.0
Lease time: 10 minutes
Primary DNS IP address: 129.1.1.1
Secondary DNS IP address: 129.1.2.2
Show DHCP client table
Description: This command displays entries in the dynamic DHCP Assignment Table.
Example:
Command> show dhcp client table
HostName IP-Address Mac-Address Lease-Expires Entry Network
------------------------------------------------------------------------ -------
User1 192.168.1.133 00-40-05-35-AB-41 10-09-02 16:04:18 dynamic LAN
User2 192.168.1.134 00-40-05-35-AB-42 10-09-02 16:04:18 dynamic WLAN
Enable DHCP server
Description: This command enables the Dynamic Host Configuration Protocol server
feature in the 802.11G ACCESS POINT. When enabled, the 802.11G ACCESS POINT will
service DHCP client requests and will respond with IP address, net mask, DNS and the
default gateway’s IP address assignment.
Example:
Command> enable dhcp server
DHCP server is enabled.
Disable DHCP server
Description: This command disables the Dynamic Host Configuration Protocol server
feature in the 802.11G ACCESS POINT. When disabled, the 802.11G ACCESS POINT will
not respond to DHCP/lease requests. Existing leaseholders will not be able to renew their
leases from the 802.11G ACCESS POINT after the lease term expires, unless another DHCP
server exists in the network.
Example:
Command> disable dhcp server
DHCP server is enabled.
Show DHCP server
Description: This command shows dhcp server settings.