User's Manual

1 Getting Started WNC RFID Smart Reader
Wistron NeWeb Corporation© 6
1.6 Connecting the Cables
Basic installation:
1. Plug an RF cable into an antenna port and an antenna. The Reader supports up to four
antennas at the same time.
2. Connect an RJ-45 Ethernet cable to the WAN port and to your computer for software
development interface configuration.
3. Connect the power adapter to the DC IN inlet on the Reader. Once the power adapter is
connected to the Reader, the Power LED indicator will turn green indicating the power is on.
Note: Reader may be wall-mounted. Insert screws via the four holes on the left and right side of
the Reader.