User's Manual

19
5. Select “TCP/IP Property” tab. Enter the settings and click “OK” to save the
settings.
n If the network uses DHCP server, choose “Obtain an IP address automatically”.
n If the network does not use DHCP server, choose “Use the following IP address”
to set the relative settings. For the IP configuration information, please contact
the network administrator.
5.1.2 Default Settings Windows XP Zero-Configuration
You may also choose the default parameters and directly proceed to Windows XP
zero-configuration through the steps below:
1. Go to “Control Panel” and open “Network Connections”.
2. Right-click the Wireless Network Connection of “WLAN a+b+g mini-PCI
Module”, and make sure this connection is Enabled.
3. Right-click the Wireless Network Connection of “WLAN a+b+g mini-PCI
Module”, and then click “Properties”.
4. Select “Wireless Networks” tab and select “Use Windows to configure my
wireless network settings” check box.
Note! Clear the check box of “Use Windows to configure my wireless network
settings” will disable automatic wireless network configuration.