User's Manual

select “Discover Available Services” to update the available services list.

4. Double-click “Bluetooth Serial Port”. The communications port number assigned to

this connection by the client is displayed in the pop-out dialog box. The application

using this connection must be configured to send data to this port.

The application on the server must use the correct communications port.

Follow the steps below to determine and configure the communications port being used by

the service:

! On the server, in “My Bluetooth Places”, right-click “My Device”. When the

pop-up menu appears, choose Properties. “Bluetooth Configuration” panel

appears.

! Click “Local Services”.

! Double-click “Bluetooth Serial Port” in the Service Name column to display its

Service Properties dialog box in which you can find the communications port the

connection is using.

To close a Bluetooth serial port connection from the client, follow the steps below:

! On the client, in “My Bluetooth Places”, highlight the device providing the

Bluetooth Serial Port service.

! In “My Bluetooth Places”, right-click “Bluetooth Serial Port”. Select

“Disconnect Bluetooth Serial Port” from the pop-up menu.

To close a connection from the server (not recommended), follow the steps below:

! On the server, in “My Bluetooth Places”, right-click “Bluetooth Serial Port” and

select “Stop”. Re-start the service before it is ready to remote devices (right-

click “Bluetooth Serial Port” and select “Start” from the pop-up menu).

4.3 Dial-Up Networking

Dial-Up Networking service allows a Bluetooth client to use a modem that is attached to the

Bluetooth server. The client can use the server’s modem as if it were a local device on the

client.

Follow the steps below to establish a Dial-Up Networking session (a connection is initiated

from the client):

1. On the client, in “My Bluetooth Places”, double-click “Entire Bluetooth

Neighborhood”.

2. In “Entire Bluetooth Neighborhood”, right-click anywhere except on a device

name and choose “Refresh” from the pop-up menu.