User's Manual

Subject: UMC-I210C User Manual REV: 2.3
PAGE 5 OF 12
Wistron Neweb Corporation Proprietary & Confidential
Design Document
2. Test Setup Configuration
2.1 Power Supply and Debug Console Connection
Power on Sequence:
I. Connect 12-pin-to-Jig-baord cable
II. Attach AC-DC Adaptor & USB Debug Port Cable
III. Wait for 20 seconds when system ready (See Note 1)
IV. Plug-in Console Port cable
[Caution] Improper power on sequence might lead to system boot-up
failure!
AC
-
DC
5V
Adaptor
Interface Board
DUT (CB)
USB Debug Port
Console