MODEL: DAUK-W12 Date: 2016/12/01 Delivery Specifications Product Description 802.11a/b/g/n/ac Wireless LAN Module Customer Part Number 098001402081 WNC Part Number 91DAUK13.G32 WNC Model Name Issue Version : DAUK-W12 V1.9 Wistron NeWeb Corporation (WNC) Manufacturer Address: 20 Park Avenue II Road, Hsinchu Science Park, Hsinchu 308, Taiwan, R.O.C.
MODEL: DAUK-W12 Revision History Version V1.0 V1.1 V1.2 V1.3 V1.4 V1.5 V1.6 V1.7 V1.8 V1.9 Confidential.
MODEL: DAUK-W12 Contents 1. Product Introduction .................................................................................................. 4 2. Product Photograph ................................................................................................... 5 3. Functional Block Diagram ......................................................................................... 6 4. I/O Pin Definition.........................................................................................
MODEL: DAUK-W12 1. Product Introduction DAUK-W12 is a 802.11 a/b/g/n/ac WLAN module which compliant with IEEE802.11n/ac standard supports 2x2 ac/a/b/g/n MIMO technology with data rate from MCS 0-15 in 20MHz/40MHz/80MHz Channels. Features Full IEEE 802.11 a/b/g/n/ac legacy compatibility with enhanced performance Dual-stream spatial multiplexing up to 866.
MODEL: DAUK-W12 2. Product Photograph Top side Bottom side Confidential.
MODEL: DAUK-W12 4. Product Specification 5.1 Specifications Item Main chipset TX/RX Host interface Operation voltage Frequency range PCB dimension Key specifications Modulation technique Realtek RTL8812AU-VS 2T2R USB 2.0 5V DC +/- 5% 2.400 ~ 2.483GHz, 5.15 ~ 5.85GHz 100mm*17mm*1.0mm, 4L, FR4 802.
MODEL: DAUK-W12 5510 5795 13 13 13 13 13 13 13 13 13 13 13 13 13 13 13 13 802.11ac HT80 Test Frequencies MCS0 MCS1 MCS2 MCS3 MCS4 MCS5 MCS6 MCS7 MCS8 MCS9 5210 9 9 9 9 9 9 9 9 9 9 5530 9 9 9 9 9 9 9 9 9 9 5775 9 9 9 9 9 9 9 9 9 9 RF output power is limited by regulatory rule in each country, so the actual output power would be minimum (target power, regulatory limit power) at each channel. The transmit modulation accuracy is measured using error vector magnitude (EVM).
MODEL: DAUK-W12 HT40 (MCS0) BPSK (MCS1) QPSK (MCS2) QPSK (MCS3) 16-QAM (MCS4) 16-QAM (MCS5) 64-QAM (MCS6) 64-QAM (MCS7) 64-QAM Code Rate Confidential.
MODEL: DAUK-W12 64-QAM 64-QAM 2/3 3/4 Code Rate BPSK BPSK QPSK QPSK 16-QAM 16-QAM 64-QAM 64-QAM IEEE Spec (1Rx dBm) -82 -81 -79 -77 -74 -70 -66 -65 Typical (1Rx dBm) -90 -88 -86 -84 -80 -77 -71 -70 Code Rate Relative constellation error (dB) Typical (1Tx dB) 1/2 1/2 3/4 1/2 3/4 2/3 3/4 5/6 -82 -79 -77 -74 -70 -66 -65 -64 -88 -85 -82 -78 -74 -72 -71 -70 HT40 (MCS0) BPSK (MCS1) QPSK (MCS2) QPSK (MCS3) 16-QAM (MCS4) 16-QAM (MCS5) 64-QAM (MCS6) 64-QAM (MCS7) 64-QAM 1/2 1/2 3/4 1/2 3/4
MODEL: DAUK-W12 Transmit spectrum mask Transmit spectrum flatness Transmit center frequency tolerance Carrier suppression Transmit power on ramp and power down ramp Confidential.
MODEL: DAUK-W12 time greater than 2 µs. 802.11a Modulation Code Rate 802.11b Modulation DBPSK DQPSK CCK Receiver maximum input level Operation temperature Storage temperature Antenna IEEE Spec (1Rx dBm) >-10 >-10 >-10 802.11g Modulation Code Rate IEEE Spec (1Rx dBm) >-20 802.11na Modulation Code Rate IEEE Spec (1Rx dBm) >-30 802.11ng Modulation Code Rate IEEE Spec (1Rx dBm) >-20 802.
MODEL: DAUK-W12 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
MODEL: DAUK-W12 This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna, 3) For all products market in US, OEM has to limit the operation channels in CH1 to CH11 for 2.4G band by supplied firmware programming tool.
MODEL: DAUK-W12 Industry Canada statement: This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
MODEL: DAUK-W12 Caution: (i) the device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems; (ii) for devices with detachable antenna(s), the maximum antenna gain permitted for devices in the bands 5250-5350 MHz and 5470-5725 MHz shall be such that the equipment still complies with the e.i.r.p.
MODEL: DAUK-W12 Les opérations dans la bande de 5.25-5.35GHz sont limités à un usage intérieur seulement. Radiation Exposure Statement: This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Déclaration d'exposition aux radiations: Cet équipement est conforme Canada limites d'exposition aux radiations dans un environnement non contrôlé.
MODEL: DAUK-W12 End Product Labeling The final end product must be labeled in a visible area with the following: “Contains IC: 4441ADAUKW12”. Plaque signalétique du produit final Le produit final doit être étiqueté dans un endroit visible avec l'inscription suivante: "Contient des IC: 4441A-DAUKW12".
