MODEL: DHUR-AN32 Date: 2017/07/28 User Manual Model Name: DHUR-AN32 Delivery Specifications Product Description STAMP module 802.11 abgn & BT WNC Part Number 81DHUR31.G01 WNC Model Name DHUR-AN32 Issue Version : V1.1 Wistron NeWeb Corporation (WNC) Manufacturer Address: 20 Park Avenue II Road, Hsinchu Science Park, Hsinchu 308, Taiwan, R.O.C. (ZIP Code: 308) Tel: +886-3-666-7799 Wistron NeWeb (Kunshan) Corporation Production Factory Confidential.
MODEL: DHUR-AN32 Production Country People's Republic of China PO Reception & Invoice ANC holding Corporation Release Company P.O. Box 3152, Road Town, Tortola, British Virgin Islands Confidential.
MODEL: DHUR-AN32 Revision History Version 1.0 1.1 1.2 Change history Draft version 1. Update Power-on Sequence Specifications in page 9 2. Module board thickness tolerance in page 21 3. Add EEPROM information in page 16 4. Add Module Photo in page 4 5. Add Clamshell Embossed Carrier information in page 29 Confidential.
MODEL: DHUR-AN32 Contents 1. Production Introduction ............................................................................................. 4 2. Photo Photograph ...................................................................................................... 5 3. Functional Block Diagram ......................................................................................... 6 4. I/O Pin Definition.........................................................................................
MODEL: DHUR-AN32 1. Product Introduction DHUR-AN32 is a 802.11 a/b/g/n WLAN/Bluetooth Combo Module which compliant with IEEE802.11n standard supports 2x2 a/b/g/n MIMO technology with data rate from MCS 0-15 in 20MHz/40MHz Channels, and BT4.2 LE specifications. Features Operation at 2.4~2.5GHz and 5.15~5.825GHz frequency band to meet worldwide regulations Bluetooth v4.2 Low Energy(LE); Bluetooth specification v2.
MODEL: DHUR-AN32 2. Product Photograph Top side Bottom side Confidential.
MODEL: DHUR-AN32 4. I/O Pin Definition Pin list Pin 1 2 3 4 5 Confidential. Name GND ANT0 GND GND ANT1 Pin 6 7 8 9 10 Name GND GND BT_ANT GND USBDP Pin 11 12 13 14 15 Name USBDM 3.
MODEL: DHUR-AN32 5. Product Specification 5.1 WiFi portion Item Main chipset TX/RX Frequency range Modulation technique Key specifications MTK MT7632TU 2T2R 2.400 ~ 2.497GHz,5.15GHz ~ 5.85GHz 802.11 a/b/g DSSS (DBPSK, DQPSK, CCK) OFDM (BPSK, QPSK, 16-QAM, 64-QAM) DSSS (Direct Sequence Spread Spectrum) with DBPSK (Differential Binary Phase Shift Keying 1Mbps), DQPSK (Differential Quaternary Phase Shift Keying 2Mbps), and CCK (Complementary Code Keying 5.
MODEL: DHUR-AN32 802.11a Test Frequencies 5180 5320 5500 5600 5700 5825 802.11b Test Frequencies 2412 2472 2484 802.11g Test Frequencies 2412 2442 2472 Output power (for each chain; tolerance +1.5/-1.5 dB) 6-12_Target 18_Target 24_Target 36_Target 48_Target 54_Target 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 1/2_Target 15 15 15 5.
MODEL: DHUR-AN32 QPSK 16-QAM 16-QAM 64-QAM 64-QAM 802.11b Modulation DBPSK DQPSK CCK 802.11g Modulation BPSK BPSK QPSK QPSK 16-QAM 16-QAM 64-QAM 64-QAM 802.
MODEL: DHUR-AN32 (MCS14) 64-QAM (MCS15) 64-QAM 802.
MODEL: DHUR-AN32 QPSK QPSK 16-QAM 16-QAM 64-QAM 64-QAM 1/2 3/4 1/2 3/4 2/3 3/4 -79 -77 -74 -70 -66 -65 -86 -84 -82 -78 -74 -72 802.
MODEL: DHUR-AN32 center frequency tolerance Carrier suppression 802.11a: The leakage of the center frequency component shall not exceed -15 dB relative to overall transmitted power or, equivalently, +2 dB relative to the average energy of the rest of the sub-carriers. 802.11b: The RF carrier suppression, measured at the channel center frequency, shall be at least 15 dB below the peak SIN(x)/x power spectrum. 802.
MODEL: DHUR-AN32 Security Operation temperature Storage temperature Antenna PID/VID WEP, WPA ,WPA2 ,AES, TKIP o o -10 ~ 70 C o o - 35 ~ 70 C ,R.H:90% 2 I-PEX connector on module PID: 76A1, VID: 0E8D Confidential.
MODEL: DHUR-AN32 5.2 BT portion Item Key specifications Main chipset MTK MT7632TU Compliance Frequency range Initial carrier frequency tolerance Modulation technique Channel spacing Channels support Operation voltage Bluetooth v4.2 LE 2400 ~ 2483.5MHz +/- 40kHz (typical) Frequency hopping, 1600 hops/sec 1MHz 79 channels 5V +/-9% (including voltage ripple) Continuous DH5 TX Power consumption o @25 C Continuous 2DH5 TX Continuous 3DH5 TX Avg (mA) Max (mA) 38 36.5 36.5 33.
MODEL: DHUR-AN32 5.3 EEPROM Information 5.3.1 WiFi Information - WiFi MAC Address - PA parameter - Vendor ID - Product ID 5.3.2 BT Information - BT MAC Address - Vendor ID - Product ID Confidential.
MODEL: DHUR-AN32 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
MODEL: DHUR-AN32 LABEL OF THE END PRODUCT: The final end product must be labeled in a visible area with the following " Contains TX FCC ID: NKR-DHURAN32 ". If the labelling area is larger than the palm of the hand, then the following FCC part 15.19 statement has to also be available on the label: This device complies with Part 15 of FCC rules.
MODEL: DHUR-AN32 le gain maximal d’antenne permis pour les dispositifs utilisant les bandes 5250-5350 MHz et 5470-5725 MHz doit se conformer à la limite de p.i.r.e. The maximum antenna gain permitted for devices in the band 5725-5850 MHz shall be such that the equipment still complies with the e.i.r.p. limits specified for point-to-point and non-point-to-point operation as appropriate.
MODEL: DHUR-AN32 The final end product must be labeled in a visible area with the following " Contains IC: 4441A-DHURAN32 ". The Host Model Number (HMN) must be indicated at any location on the exterior of the end product or product packaging or product literature which shall be available with the end product or online. Confidential.
