Manualshelf

User's Manual

ManualsBrandsWistron NeWeb ManualsElectronics802.11 abgn 2x2 PCIe Module
21222324252627282930
Table Of Contents
LANCOM Routers, WLAN routers, access points and WLAN controllers K First Steps
4
First Steps
in the LANCOM (default = on). Contradictory settings can lead to data
transfer errors, either immediately or after some time (days).
K Connect the device to the power supply (via the supplied power
adapter unit or power cord) and switch on the power switch.
c
Searching for and configuring the device...
A LANCOM router, wireless router, access point or WLAN Controller can be
configured over the following paths (assuming that the model is equipped
with the corresponding interface).
I
If your network contains a LANCOM WLAN Controller, then the
network commissioning of access points is generally fully automatic.
For further information please refer to the user manual supplied with
your LANCOM WLAN Controller.
K Via the local network (LAN) A.
For LANCOM
wireless routers
only
K Via the wireless LAN B if WLAN encryption has been correctly set up (or
deactivated) in the configuration computer and the device with the
wireless interface.
As of LCOS version 7.22 all LANCOM access points are set to "Managed
Mode" when shipped, and the WLAN modules are switched off. For this
reason the first-time configuration of LANCOM access points via WLAN is
not possible.
K Via the serial configuration interface C.
K Via an ISDN connection D.