User's Manual
Table Of Contents
LANCOM Routers, WLAN routers, access points and WLAN controllers K First Steps
13
First Steps
K The Download section on www.lancom.eu/download contains all cross-
product elements such as the LANCOM LCOS Management System LCMS
and the LCOS documentation.
K Product-related downloads such as the latest firmware or loader versions,
and also the firmware archive, are located on the myLANCOM portal at
www.mylancom.eu.
CE-declarations of conformity
LANCOM herewith declares that the devices of the type described in this
documentation are in agreement with the basic requirements and other rele-
vant regulations of the 1995/5/EC directive.
The CE declarations of conformity for your device can be found on the relevant
product page on the LANCOM Web site (www.lancom.eu).
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interfe-
rence that may cause undesired operation.
WARNING: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interfe-
rence in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communicati-
ons. However, there is no guarantee that interference will not occur in a par-
ticular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
K Reorient or relocate the receiving antenna.
K Increase the separation between the equipment and receiver.
K Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
K Consult the dealer or an experienced radio/TV technician for help.
The user may find this booklet prepared by the Federal Communications Com-
mission helpful: