User Manual

11
Steps for Network Inclusion
You can start the inclusion process by pressing and holding the Gateway sync button for two seconds so the
rotating “inclusion mode” pattern appears on the Gateway activity indicator. When this is completed, the Gateway
is ready to perform the inclusion of the other GreenWave Reality device.
If you attempt to include a GreenWave Reality device from another energy management system with an
“alien” Gateway, the inclusion will fail and the indicator bars will flash rapidly.
To complete the inclusion process on a PowerNode, you must perform the following steps (refer to the user
guide that came with your PowerNode for more information):
1. Plug the PowerNode into an electrical outlet.
2. Locate the sync button on the PowerNode. It is a small round button on the side of the device, marked
with the sync symbol.
3. Press and hold the sync button for one second until the PowerNode activity indicator begins to display a
clockwise-rotating pattern, which shows that the PowerNode is attempting inclusion.
4. After a few seconds, the rotating pattern should stop and all bars turn green for five seconds to indicate
successful inclusion. The PowerNode is now part of your energy management system, and you can
connect an appliance and electronic device (refer to the instructions that came with your PowerNode to
plug in your appliance or electronic device).
If the rotating pattern has stopped but all bars did not turn green for five seconds, then the PowerNode
inclusion process has failed, and you must start over.