User Manual
To complete the inclusion process on an In-Home Display, you must perform the following steps (refer to the
user guide that came with your Display for more information):
1. Make sure you are on the JOIN NETWORK screen on the In-Home Display.
2. Press the select button on the Display to have it start the inclusion process.
3. When the Display connects successfully, the screen shows the message CONNECTED.
If the screen shows the message UNSUCCESSFUL, then the inclusion process has failed, and you
must start over.
Network Exclusion Process
Note: If the GreenWave Reality device that you are connecting to the Gateway is new and has never been used
before, then you should not need to perform the exclusion process.
A GreenWave Reality device that has been previously used with a different Z-Wave network must have its
association (homeID) with the other network removed before you can connect it to your GreenWave Reality
energy management system. This process is called “exclusion” and requires two steps: one that must be
performed with the Gateway and then one that is performed with the other GreenWave Reality device.
Steps for Network Exclusion
You can start the exclusion process through your Gateway user interface or by pressing and holding the
Gateway sync button for five seconds until the “exclusion mode” pattern appears on the Gateway activity