User Manual

13
indicator. When this is completed, the Gateway is ready to perform the exclusion of the other GreenWave Reality
device.
To complete the exclusion process on a PowerNode, you must perform the following steps (refer to the user
guide that came with your PowerNode for more information):
1. Unplug the PowerNode from the electrical outlet.
2. Locate the sync button on the PowerNode. It is a small round button on the side of the device, marked
with the sync symbol.
3. Press and hold the sync button while plugging the PowerNode into an electrical outlet. Keep the button
pressed for five seconds until all bars turn green for five seconds, indicating that the exclusion process
has completed. Your PowerNode is now free of its former association, and you can perform an inclusion
process to include it in your GreenWave Reality energy management system (refer to the “Network
Inclusion Process” section above).
If the network indicator and power button symbol flash together slowly for five seconds, then the
exclusion process failed, and you must start over.
To complete the exclusion process on an In-Home Display, you must perform the following steps (refer to the
user guide that came with your Display for more information):
1. Make sure you are on the LEAVE NETWORK screen on the In-Home Display.
2. Press the select button on the Display to have it start the exclusion process.
3. When you are prompted to confirm, press the select button again.
4. When the Display disconnects successfully, the screen shows the message COMPLETED.