User's Manual
Table Of Contents
- Contact Information
- Revision History
- Contents
- 1.Introduction
- 2.Electrical Specifications
- 3.RF Specifications
- 4.Software Interface
- 5.Mechanical and Environmental Certifications
- 6.Regulatory Compliance and Certification
- 7.Safety Recommendation
24
/
37
□ Normal □ Internal Use Confidential □ Restricted Confidential
User Manual
2.8.5. I2C Interface
Adding pull-high resistors to 1.8 V through the 2.2 kΩ resistors is recommended.
Figure 9. I2C connection (example)
2.8.6. UART Interface
There are two UART interfaces: One is a 4 bit UART for high-speed data transfer, and the other is a 2 bit
UART for diagnostic tools and debugging.
Figure 10. UART connection (example)